Motorized sheet metal shears with NC-controlled back gauge

Thin sheets are supported in order to be able to apply dimensionally to the back gauge
the pneumatic sheet holding device with selector lever for the direction of the sheet metal chute
The operator can choose if the section falls into the backroom or the operator side
Powerful drive via gearbox-supported motor and massive chain
Backs can be guided on round shafts 750 mm driven by ball screws
Positioning control of back gauge Mapper HT071 with digital dimension display
heavy and robust steel construction in welded construction
constant, low cutting angle for optimum cutting results
Control panel on the left side of the machine Side stop 1.000 mm with scale and T-slot
2 material support arms 500 mm with T-slot
Balls in the support table for easier material transport
Cutting gap adjustment with a ratchet wrench and vernier ring
high-quality knife (also suitable for stainless steel)
Cutting edge LED lighting with silhouette
Rear room safety with side plates and light barrier
continuous finger protection device
mobile foot pedal with EMERGENCY STOP switch
All moving parts are stored with low maintenance
Electrics from “Siemens” and “Schneider”

Optional accessories:

Extension of the back gauge from 750 mm to 1,000 mm
Miter fence Adjustable, removable miter fence for angles from 0 ° -180 °
Manual central lubrication
Mobile sheet metal tray: Mobile tray for the rear space of the machine. Maximum load 300 kg

Length (product) approx.	2070 mm
Width / depth (product) approx.	2120 mm
Height (product) approx.	1110 mm
Weight (net) approx.	1190 kg
Recording power drive motor	3.5 kW
Output power drive motor	3 kW
Total connection value	4 kW
Total current consumption	7.82 A
Nominal mode drive motor	S1
Duty cycle drive motor	100%
Electrical voltage	400V
Phase (s)	3
Current Type	~
power frequency	50 Hz
Cutting length max.	1350 mm
Cutting performance at material tensile strength 400 N / mm²	3 mm
Cutting performance at material tensile strength 450 N / mm²	3 mm
Cutting performance at material tensile strength 700 N / mm²	1.5 mm
cutting speed	80 m / min
Backgauge adjustment range up to	750 mm
Backgauge speed	28 mm / s
Engine power backgauge	0.37 kW
Side stop length	1000 mm
cutting angle
Strokes max. at full cutting length	40 1 / min
Sheet metal low number	2
Cutting gap adjustment min.	0.05 mm
Cutting gap adjustment max.	0.4 mm
Table length	1507 mm
Table depth	420 mm
Table height	800 mm
Deep machine body	680 mm

MTBS 1350-30 T