Stable drilling and milling machine with an electronically infinitely variable drive.
Feed spindles adjustable without backlash by adjustable spindle nuts
Stable dovetail guide, precision ground and scraped with adjustable wedges
EMC filter class B (use in private households)
All guides are ground and visibly scraped (oil pockets for lubrication)
Precisely processed
Double-row angular contact ball bearings in the axles, adjustable without backlash
Safety electronics in 24 Volt version
Bellows as guide protection
Forward / reverse operation
Drilling and milling head inclinable by ± 90, for milling and drilling work in any angular position
machine lamp
Height-adjustable protective screen with microswitch against flying chips and parts for the utmost protection of the user
Easy to read speed display and depth display, switchable mm / inch
fine feed

Room amenities

engine
- Two-stage gear ratio for powerful transmission of engine power
- Powerful DC motor with permanent current monitoring

control panel
- User-friendly membrane keyboard
- Easy to read digital speed display
- clear
- Emergency stop impact switch

pillar
- Reversible on both sides by 30 mm
- With swiveled head, longer travel paths, and centric machining of the workpiece possible
- Back with hole
- Slightly oil the trapezoidal spindle or grease off the ball screws

length	750 mm
Width depth	650 mm
height	820 mm
Weight (net)	94 kg
Power drive motor	750 W
Supply voltage	230V
Phase (s)	1 Ph
Current Type	~
power frequency	50 Hz
Knife head size max.	52 mm
End mill size max.	20 mm
Vertical spindle projection	170 mm
Vertical spindle Spindle mount	MK 2
Vertical spindle speed range	100 – 3000 min-1
Vertical spindle Number of speed ranges	2
Vertical spindle Control of the speed control	electronic
Horizontal milling length	510 mm
Horizontal milling width	180 mm
Distance vertical spindle – horizontal milling min.	255 mm
Distance vertical spindle – horizontal milling table max.	255 mm
Horizontal milling T-slots size	12 mm
Horizontal milling T-slots number	3
Horizontal milling T-slots clearance	63 mm
Horizontal milling load max.	50 kg
Traverse X-axis manually	280 mm
Travel Y-axis manually	175 mm
Travel Z-axis manually	210 mm
Drilling capacity steel (S235JR)	16 mm
Continuous drilling capacity steel (S235JR)	12 mm
Vertical spindle Turning area milling head Z – X plane	90 degrees
Vertical spindle Pinole diameter	60 mm
Vertical spindle Quill stroke	50 mm
EMC class	C1

Vari Speed Drill Mill - OPTImill MH 20V (230v)